Textile Structure
how cloth is put together
Concept

Locking angle — where it appears

The shear at which a cloth's threads jam against their neighbours, arcsin of the diameter over the pitch, past which the fabric cannot deform further. It is a hard bound rather than a soft one, and no figure on this site draws a cloth sheared past its own.

Named by 3 essays across 2 fields — each of them below, with the objects they name alongside it.

How far the bias goes, and where it stops. Extension along the bias against shear angle, with the angle at which the threads jam marked for three settings. The curve is geometry and so is the wall — a more closely set cloth reaches it sooner.

The locking angle

The bias runs out at an angle that yarn diameter and thread spacing decide between them. It is the number behind whether a cloth will go round a curve, and it has nothing to do with how strong the fabric is.

mechanics · Bias How much of the curvature a cloth can take without being cut. The dart angle a spherical cap still demands after the fabric's own shear has absorbed what it can, against how closely the cloth is set. The total the cap demands is fixed by Gauss–Bonnet and is the same for all of them; what changes is how much of it the trellis can supply before its threads jam. An open cloth drapes a hemisphere with no dart at all; a closely set one has to be cut from the start.

A hemisphere costs one full turn

The total angle a pattern must remove to cover a hemisphere is exactly 360 degrees, and it is the same for a hat and for a stadium dome. What changes with the fabric is how much of that the cloth can supply by shearing instead of by being cut — and that is a property of the sett, computed from the angle at which its threads jam.

applied · Cutting The shear a dome demands, against how far round it the cloth reaches. A flat sheet of inextensible threads takes a double curvature only by shearing, and the shear it needs depends on how far round the dome it has to reach rather than on how big the dome is — a knee, a shoulder and a beach ball demand exactly the same at the same fraction of their own radius. The horizontal line is the locking angle for a sheeting, where the threads are touching side by side and the mechanism has nowhere left to go. Reaching one radius round takes the cloth to 85% of that, and reaching 1.2 radii passes it. What the plot cannot show is the frictional part: a shear well inside the locking angle is still a shear at crossings friction is holding, so a knee that is domed a thousand times keeps a little of each one.

A knee is a dome imposed a thousand times

A flat sheet of inextensible threads takes a double curvature only by shearing, and how much shear it needs depends on how far round the dome it has to reach — not on how big the dome is. So a knee and a beach ball demand the same, and a trouser knee covered to its own equator is at 85 per cent of the angle at which the threads touch side by side.

applied · Damage

Named alongside it

The objects these essays reach for when they reach for this one.

ShearDartDrapeBaggingCoverDevelopableDouble curvatureFishnetGaussian curvatureInextensibleInterchange budgetJamming

All concepts