Gauge-length — where it appears
Named by 3 essays across 2 fields — each of them below, with the objects they name alongside it.
A yarn breaks at its thinnest place
A tensile test does not measure a yarn. It measures the worst section between the clamps — so evenness and strength are one measurement taken twice, and the number of independent tries in a specimen is set by the length of a fibre.
A warp breaks in a tail no tensile test reaches
A 500 mm tensile test is the weakest of about eighteen staple lengths of yarn. A warp of four thousand ends by a thousand metres is the weakest of a hundred and forty million, and an end breaks wherever one of them is weaker than the shed's tension. Three strength laws fitted to the same two tensile tests agree within five per cent at every gauge a tester can clamp, and disagree by a factor of 375,000 on how many ends a warp will break at the back shaft.
A break log reads the tail only above its fault floor
A loom's record of warp breaks by shaft is a reading of the yarn's strength at twenty-four tensions at once, which no tensile certificate can give. But a slub or a bad piecing breaks on whichever shaft it reaches, so discrete faults lay an even floor under the log, and one fault in a hundred kilometres of yarn is forty breaks a beam. Over that floor a normal yarn's tail reports a steepness of 3.8 where its own is 39, a lognormal's never shows at all, and the two can be told apart only by twenty-two beams of log. A Weibull yarn, which breaks sixty times a beam on its own, is identified inside one.
Named alongside it
The objects these essays reach for when they reach for this one.
EvennessHarnessShedBundle strengthFaultFibre countLimit irregularityOrder statisticPopulationSpecificationStaple lengthTenacity