Textile Structure
how cloth is put together
Concept

Finishing — where it appears

Everything done to a cloth after it leaves the loom — relaxing, shrinking, calendering, raising, milling. A finished fabric is not the one that came off, so a dimension without a state attached to it is not a dimension.

Named by 3 essays across one field — each of them below, with the objects they name alongside it.

The same thread, on the loom and off it. One warp end in section over eight picks, drawn twice at the same scale. The thread is the same length in both panels; in the lower one more of that length is in the bends, so the cloth it spans is shorter. Nothing has been lost — the length has moved into the crimp. The thread's thickness and the height of its bends are drawn larger than scale so the interlacing is legible; the two panels' spacings are not.

What comes off the loom is not the cloth

Every number on this site so far describes a fabric in one particular condition — held under tension, stretched to the reed width, never wetted — and none of them says so. That condition lasts until the cloth is taken off the machine, which is the first thing that happens to it.

finishing · State What a pre-shrunk label promises. Three lengths of the same cloth: as woven, as it leaves the compressive-shrinkage machine, and where it will finally settle. The residual shrinkage quoted on a label is measured against the second of these and the total against the first, so the two numbers are not the same quantity and cannot be subtracted.

Pre-shrinking is a subtraction done in advance

A compressive-shrinkage machine takes four per cent out of a cloth before anybody buys it, and the label then quotes what is left. The two numbers are fractions of different lengths, so they cannot be subtracted — and the difference between doing that correctly and incorrectly is most of the number.

finishing · Shrinkage From a calender's line load to a force at one crossing. A sheeting through a nip loaded at 30 N per millimetre of bowl width, with the cloth in contact over 5.0 mm. The pressure is the first divided by the second, 6.00 N/mm², and the force at one crossing is that pressure times the area a crossing owns — the product of the two thread spacings, 0.1374 mm². So the crossing carries 0.824 N, the sections flatten to 2.42 and 2.63, and the cloth thins from 0.388 mm to 0.218 mm. What the drawing cannot show is that two cloths through the same nip are not given the same treatment: the area a crossing owns varies fivefold across the standard cloth table, and it is a factor in the force.

A calender spends the compression for good

Calendering was described here as moving a cloth from one thread-section model to another, which was right and had no number in it because the amount of the move was a free parameter. It is a pressure now — and the same nip setting turns out to give two cloths quite different treatments, because the force at a crossing is the pressure times the area a crossing owns.

finishing · Lustre finish

Named alongside it

The objects these essays reach for when they reach for this one.

CrimpLoom-stateRelaxationShrinkageCalenderingCloth thicknessCompression energyContact forceCoverCover factorFloatLustre

All concepts