Concept

Divisor — where it appears

A number that divides another exactly, which is what a repeat has to be of a warp's body if the pattern is to fit. Divisors are rare — a body of a few thousand ends has a few dozen in the range a design might use — so a repeat chosen for any other reason leaves a remainder, and the remainder averages half a repeat.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A repeat across a 1800-end warp. Four repeat widths laid across the same 1800-end warp, drawn at the warp's own scale. The pale bands at the two ends are the selvedge threading, 24 ends each, which weaves its own firmer weave and is not part of the design. Between them the body is ruled into whole repeats, alternating so they can be counted, and the marked bands at the two sides are the remainder — the part of a repeat that did not fit, split between the two selvedges because the trade centres the pattern. None of these four repeats divides the body exactly, and the leftovers run from 2 to 24 ends. What the drawing cannot show is what the break looks like: a quarter of a repeat at the selvedge reads as a border and half of one reads as a mistake, and where the line between those falls is a judgement.

A repeat has to fit the width

A repeat tiles the plane and a warp has two edges, so somewhere between them a repeat is cut through. The set of repeat widths that divide a warp exactly is the set of divisors of its body, and a body of a few thousand ends has a few dozen — two to eight per cent of the candidates. So a designer choosing a repeat for any reason except the width chooses one that does not fit, and the leftover averages half a repeat, split between the two selvedges.

cloth · Repeat

What matching a pattern costs a cutting room. The cloth a matched panel needs beyond its own length, against the pattern repeat, for 6 panels of 70 cm. Every panel of a patterned cloth must start at the same phase of the repeat or the pattern breaks at the seams, so a panel's cut length is rounded up to a whole number of repeats. The bar is the allowance a cutting room budgets — a whole repeat a panel, because a panel's length is not a multiple of anything — and the mark is the waste actually expected, which is half a repeat. The two differ by (L + r)/(2L + r), which is between a half and two thirds and is nearer two thirds the larger the repeat. The rows marked in the second colour are the repeats that happen to divide the panel exactly and waste nothing at all, which is what makes the real cost jagged rather than smooth. What the bars cannot show is nesting: a cutting room lays many panels on one length and a short panel can sometimes be taken from another's waste.

A repeat has to fit the panel, and the panel is cut

The warp's width is fixed at warping and a piece's length is not, so the fitting problem in the two directions is not the same problem. Along the length a repeat has to fit a *panel*, because every panel of a patterned cloth must start at the same phase or the pattern breaks at the seams — and the allowance is a whole repeat per panel. A ten-centimetre repeat costs a seventy-centimetre panel twelve and a half per cent and a sixty-four-centimetre repeat costs it forty-eight.

cloth · Repeat

Named alongside it

The objects these essays reach for when they reach for this one.

Repeat Selvedge Cutting Finite fabric Point paper Specification Warp Waste

All concepts