Textile Structure
how cloth is put together
Series

Take-up — the series

3 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. The reed is not the sett. Twelve ends held at the reed's pitch above and at the cloth's pitch below, for a sheeting whose weft crimp is 14.61 per cent. The count is the same in both rows and only the spacing changes: the cloth is 12.75 per cent narrower, so a reed at 24.43 ends per centimetre produces a cloth at 28. The crimp comes from the Peirce solution at this cloth's quoted construction.

    The reed is not the sett

    A reed holds the warp at a pitch, and the cloth that leaves it is narrower — by exactly the weft's crimp, with nothing fitted and nothing approximated. On a close balanced sheeting that is 12.75 per cent, on an open scrim 1.87, and a weaver who allowed one figure for both would be wrong by a factor of nearly seven.

    part 1 · setting
  2. What the two setts can be set to. Two rules on one scale from 8 to 40 threads per centimetre. The upper carries the 49 warp setts a metric reed catalogue reaches at one to four ends per dent; the lower carries the 4825 pick densities a change-wheel take-up reaches. The mean spacing is 0.656 threads per centimetre in the warp and 0.0066 in the weft, a ratio of 99. The widest gap in the reed's range is 2.10 threads per centimetre.

    The setts a loom can reach

    Transposing a draft gives a perfectly good draft, and every count this site takes off a matrix either is symmetric under exchanging warp and weft or has a mirror twin. The loom is not symmetric at all: over the range ordinary cloth is woven in, it can choose a pick density 99 times more finely than a warp sett — and the warp sett cannot be changed once the warp is drawn in, at any granularity whatever.

    part 2 · setting
  3. How far each cloth's sett moves between the loom and the finished state. A cloth on the loom is held: the warp is under beam tension and the picks are driven up at whatever density the take-up says. Let it go and it relaxes to the least-energy state of its own locus, which is a state at a different sett. The bars are how far each sett moves, and they always move in opposite directions because there is one locus: warp ends per centimetre fall as the cloth widens and picks per centimetre rise as it shortens. Seven of the eight move a little over one per cent; the poplin, whose two counts and two setts are the only unbalanced pair in the table, moves six and ten. What the bars cannot show is what a designer does with them, which is that the two numbers a specification quotes are not two free numbers — the finished construction is a point on a one-dimensional curve.

    The construction a loom must be set to

    A specification quotes ends and picks per centimetre in the finished cloth, and a loom is set to neither of them. The cloth relaxes to the least-energy state of its own locus, which is a state at a different sett — and because the locus is one curve, the two numbers a specification quotes are not two free numbers.

    part 3 · setting

All series