Textile Structure
how cloth is put together
Series

Shed — the series

3 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. The shed in section. A warp line 1200 mm from the fell of the cloth at the left to the back rest at the right, with 8 shafts at 300 mm and every 16 mm behind it. Each shaft lifts its ends in proportion to its own distance from the fell, which is what gives the same 30 mm clear opening at the reed from every shaft. The resulting extension is 0.460 per cent at the front shaft and 0.722 per cent at the back, a ratio of 1.57. Vertical scale exaggerated 4 times.

    The shed is an extension

    Every model of a finished cloth treats a thread as inextensible, and every one of them is about a fabric that has left the loom. On the loom the warp is stretched thousands of times a minute by the shed itself, and the amount is exact trigonometry with nothing fitted in it: the square of the shed's tangent, times the shaft's own distance from the fell, over twice what is left behind it.

    part 1 · mechanics
  2. The strain across a harness. The warp strain each shaft of a 24-shaft harness puts into its own ends, from 0.460 per cent at the front to 1.728 per cent at the back. Shafts within a budget of 1.0 per cent are drawn in one colour and those outside it in another; the budget is reached at shaft 13.

    The back shaft works hardest

    How hard the loom is on a warp end is the product of two numbers from different worlds — how often its column changes sides, which is a property of a binary matrix with no millimetre in it, and the strain of the shaft it happens to be on, which is a property of a machine with no weave in it. Neither knows about the other, and the threading that joins them is a decision nobody makes on structural grounds.

    part 2 · mechanics
  3. Flexes per end in the same check, ground a pick along. One bar per warp end above the draft of the same check, ground a pick along, each the number of times that end changes sides in one repeat — which is the number of times the shed drags it through its heddle eye. The counts run from 6 to 10, and they are the same numbers that give the cloth its interlacing rate of 0.500 per intersection.

    A figure is harder on its warp

    Every basic weave flexes all its ends exactly as often as each other — plain, twill, satin and sateen alike, and it is a one-line theorem. Figure one of them on another and that evenness goes, or does not, depending on where the ground weave was started relative to the figure. The same invisible offset that decides whether a fine figure holds together decides, at a coarse one, how unevenly the loom works the warp.

    part 3 · mechanics

All series