Textile Structure
how cloth is put together
Generator

Everywhere a muslin can go

Everywhere a muslin can go
Everywhere a muslin can go. Every state a muslin of 24 × 22 threads per centimetre in 20 and 20 tex can reach without a yarn changing length, solved from Peirce's plain-weave geometry. The set is a curve and not a region: 6.59 per cent of extension is available along the warp, and reaching it costs 21.82 per cent of the width.

Every state a muslin of 24 × 22 threads per centimetre in 20 and 20 tex can reach without a yarn changing length, solved from Peirce's plain-weave geometry. The set is a curve and not a region: 6.59 per cent of extension is available along the warp, and reaching it costs 21.82 per cent of the width.

6 essays call tensile-plot. The drawing above is what it returns with no arguments at all; every call below passes it something, because a placement that passes nothing draws whichever member of the family the generator happens to default to rather than the weave its essay argues about.

Where it is called

Changing this generator changes every one of these figures.

Everywhere a sheeting can go. Every state a sheeting of 28 × 26 threads per centimetre in 25 and 25 tex can reach without a yarn changing length, solved from Peirce's plain-weave geometry. The set is a curve and not a region: 4.03 per cent of extension is available along the warp, and reaching it costs 6.98 per cent of the width. Mechanics and drape

A cloth extends by moving its crimp

Everybody says the extension available along the warp is the warp's own crimp. On six of eight ordinary cloths it is not — a close sheeting has 14.61 per cent of warp crimp and reaches 4.03 per cent, because the limit lives in the weft.

 Everywhere a muslin can go. Every state a muslin of 24 × 22 threads per centimetre in 20 and 20 tex can reach without a yarn changing length, solved from Peirce's plain-weave geometry. The set is a curve and not a region: 6.59 per cent of extension is available along the warp, and reaching it costs 21.82 per cent of the width. Mechanics and drape

Pulled both ways, only one can give

A cloth at constant thread length has one degree of freedom, so its reachable states are a curve rather than a region. Equal extension in both directions meets that curve at exactly one point — the state the cloth is already in — so the amount available is nought.

 A ratio that will not hold still. The exchange rate between the two directions for 4 cloths, against how far each has been extended along the warp. Every curve is above one half everywhere it is drawn, and every curve rises — so a single number for a cloth's ratio has to name the state it was read at, which a material's ratio does not. Mechanics and drape

A cloth's Poisson ratio is not a material's

The ratio of a cloth's contraction to its extension has a name everywhere else in mechanics, and it breaks every rule the name comes with — above one half on all eight cloths measured, doubling across a four per cent span, and not reciprocal between the two directions.

 The load–extension curve, computed from a stiffness. The tension in one end of a sheeting against how far the cloth has been extended, computed as the slope of its bending energy along its own constant-thread-length locus. The curve passes through zero at the state of least energy, which is where an unloaded cloth sits, and rises either side of it. What the curve cannot show is what happens after the crimp runs out: past the end of the locus the load is carried by stretching yarn rather than by straightening it, and that is a modulus three orders of magnitude higher and a different figure. Mechanics and drape

The locus gets a force

This site has drawn the set of states a cloth can reach without stretching any yarn, and has never been able to say which of them it is in or what it would cost to move. Both questions are one derivative of a bending energy — and the answer explains the flat start every fabric's load–extension curve has, which is not slack yarn but a symmetry.

 Shrinkage from wetting, cloth by cloth. The change in each cloth's relaxed construction when its threads swell by 20% across and 1.2% along. Both states are least-energy states of their own constant-thread-length locus, which is the only comparison the locus admits: its minimum is a state at its own sett, so it may be compared with another minimum and not with a quoted construction. Positive is smaller. Every cloth that has a wet state closes up except the cheesecloth, which opens by half a per cent because the fibre's extra hundredth of length outruns the extra crimp a thicker partner costs. What the bars cannot show is the three cloths that are missing, which have no wet state at all. Setting and geometry

Wetting moves a cloth to another locus

A cloth's constant-thread-length locus is built at a fixed thickness. Swelling changes the thickness, so a wetted cloth is not somewhere else on its own locus — it is on a different one, and the distance between the two least-energy states is the shrinkage. Five of the eight cloths here have a wet state, and one of them gets bigger.

 What a knit gives when it is pulled. Force against course-wise extension for a 20 tex cotton jersey at a 3.5 mm loop, computed from the loop's own bending with the relaxed shape as the yarn's natural one. The loop length is the same at every point on the curve: nothing here is the yarn stretching. It reaches 92% extension at 2.96 N per metre and then stiffens by a factor of 85 over the rest of the range, as the straight line between two interlacings runs up against the yarn between them. This is the number the collection's second phase recorded as a lower bound it could not compute, and it is still a lower bound in one respect: friction at the contacts is not in it, so a real fabric is stiffer than this and does not come back along the same curve. Knits and other structures

What a knit gives when it is pulled

How far a knit stretches by rearranging its loops is usually given as a bound rather than a number, because saying more needs a loop with bending stiffness in it. Solved from the loop's own bending, the answer is a curve: soft for a hundred per cent, then stiffening by a factor of eighty as the yarn between two interlacings runs out of ways to be anywhere but straight.

The whole library · All essays